CORRIDOREDIT command
Adds or removes regions for a selected corridor.

Icon:
Method
The CORRIDOREDIT command can be used to:
- Add or remove baselines for a selected corridor.
- Add, remove, split or merge regions for a selected corridor.
- Add stations to a selected corridor.
Options within the command
- Add Baseline
- Adds a new corridor baseline.
- Remove Baseline
- Removes a corridor baseline.
- Add Region
- Adds a new region to a selected corridor baseline.
- Enter region start station
- Allows you to enter the starting point along the 3D alignment line.
- Enter region end station
- Allows you to enter the ending point along the 3D alignment line.
- Remove Region
- Removes a selected region.
- whole Baseline
- Allows you to select the whole baseline.
- by Index
- Allows you to enter an index which corresponds to the baseline/region. Note: For regions, the index is calculated from region start station to region end station.
- by Name
- Allows you to select a baseline/region by its name.
- by Range
- Allows you to select a range baseline/region.
- Add Station
- Adds station to a region.
- Split Region
- Splits a selected region.
- Merge Region
- Merges regions.