UNDO command

Undoes one or more commands.

BricsCAD Shape; BricsCAD Lite; BricsCAD Pro; BricsCAD Mechanical; BricsCAD BIM

Icon:

Description

Undoes one or more commands. BricsCAD reports the commands being undone.

Note: Some commands cannot be undone.

Options within the command

Number of steps to undo
Specifies the number of commands to undo by entering a number.
Mark
Sets a marker.
Back to mark
Undoes all commands back to when the marker was set.
BEgin set
Sets the start to a group that groups the following commands. The UNDO command treats the commands in the set as a single undo.
End set
Ends the group of commands.
Control
Specifies several options for the command.
None
Turns off the undo mechanism.
Note: This is useful when disk space is running low, because the undo mechanism uses disk space.
One
Limits this command to a single undo. The UNDO command is changed into the U command.
All
Turns on the Undo mechanism.
Layer
Specifies whether the UNDO command combines Layer dialog operations.
Auto
Considers all commands executed by a macro as a single undo.
Note: When Control is set to None or One, the Auto, Begin and Mark options are not available.