Freezes the layers associated with entities that you select in the drawing (short for "layer freeze").
Note: Use the Layer command to thaw specific layers that were frozen with this command, or else use the LayThw command to thaw all layers in the drawing.
Accessing the Command
command bar: layfrz
menu bar: Settings | Layers | Freeze Layer
ribbon: Home | Layers | Freeze
toolbar: Layers | Freeze
: LayFrz
Prompts you in the command bar:
Current setting: Viewports=Freeze, Block nesting level=Block
Select an entity on the layer to be frozen or [Settings/Undo/selection options (?)]: (Pick an entity, or choose an option)
Entities in set: 1
Select an entity on the layer to be frozen or [Settings/Undo/selection options (?): (Select more entities, or press Enter to exit the command)
This layer has been frozen :<LayerName>
This layer has been frozen :<LayerName>
...
This layer has been frozen :<LayerName>
Note: The current layer cannot be frozen. When one or more entities on the current layer has been selected, BricsCAD reports: Cannot freeze layer: <LayerName>. It is the current layer.
Command Options
Option |
Description |
Select an entity on the layer to be frozen |
Selects a single entity whose layer should be frozen. The prompt repeats itself until you press Enter so that you can freeze more than one layer. |
Settings |
Specifies the tricky case of how layers holding viewports and blocks (and xrefs) should be frozen; prompts you: Enter setting type for [Viewports/Block selection] - (enter an option):
|
selection options (?) |
Allows to choose a selection method. See the Select command. |
Related Commands
Layer - creates layers and changes their properties in the Drawing Explorer.
-Layer - creates layers and changes their properties in the command bar.
LayerState - saves and restores layer states.
LayThw - thaws all frozen layers.
LayIso - isolates layers associated with selected entities.
LayLck - locks layers associated with selected entities.
LayUlk - unlocks layers associated with selected entities.
LayOff - turns off layers associated with selected entities.
LayOn - turns on all layers that have been turned off.