Constrains the distance between two points, or the length of a single entity, to the vertical (Y direction) in the current coordinate system. (This command is equivalent to the Vertical option of the DIMCONSTRAINT command.)
Accessing the Command
command bar: dcvertical
menu bar: Parametric | 2D Constraints | Vertical
toolbar: 2D Constraints |
ribbon: Sketch | 2D Constraints |
you are prompted:
Specify first constraint point or [Entity] <Entity>: (Select a valid constraint point, or else press Enter to select an Entity)
Specify second constraint point: (Select a valid constraint point)
Specify dimension location: (Select a point to position the dimension line)
Dimension text <xx.xx>: (Type a value, or else press Enter to accept the current value)
The vertical distance (parallel to the X-axis of the current coordinate system) between the two points is constrained.
Constrains the vertical distance between the endpoints of an entity. Prompts you:
The entity is constrained vertically (parallel to the T-axis of the current coordinate system), but can continue change its size in other directions.
Dimconstraint - applies a dimensional constraint to an entity or between constraint points on entities; converts associative dimensions to dynamic dimensions.
Geomconstraint - applies geometric relationships between entities and/or valid constraint points on entities.
DcAligned - constrains the distance between two points.
DcAngular - constrains the angle between two lines or linear polyline segments; the total angle of an arc or an arc polyline segment; or the angle between three points on entities.
DcConvert - converts an associative dimension to a dimensional constraint.
DcDiameter - constrains the diameter of a circle or an arc.
DcHorizontal - constrains the horizontal distance (X-distance) between two points with respect to the current coordinate system.
DcLinear - constrains the horizontal distance (X-distance) or vertical distance (Y-distance) between two points with respect to the current coordinate system.
DcRadius - constrains the radius of a circle or an arc.
ConstraintBar - controls the display of the constraint bar of entities.
DcDisplay - allows to set dimensional constraints to be displayed or hidden.
Delconstraint - removes all dimensional and geometrical constraints from an entity.
CleanUnusedVariables - purges variables not used in constraint expressions and not linked to dimensions.
-Parameters - manages 2D dimensional constraint parameters and user variables in the current drawing.