Constrains two lines or polyline segments to lie perpendicularly to each other. (This command is equivalent to using the Perpendicular option of the GeomConstraint command.)
Note: The second entity that you select is moved to be parallel with the first entity.
Accessing the Command
command bar: gcperpendicular
menu bar: Assembly | 2D Constraints | Perpendicular
ribbon: Parametric | 2D Constraints | Perpendicular
toolbar: 2D Constraints |
Prompts you in the command bar:
Select first entity: (Select a line or linear polyline segment)
Select second entity: (Select another line or linear polyline segment)
|Select first entity||Select a line or linear polyline segment.|
|Select second entity||Select another line or linear polyline segment. You can select two segments of the same polyline.|
After you place the constraint, icons appear near the entities indicating the type of constraint. If you do not see them, then use the ConstraintBar command to display them.
To remove a constraint, click the tiny x on the constraint bar:
GeomConstraint - applies geometric relationships between entities and/or points on entities.
Dimconstraint - applies a dimensional constraint to an entity or between constraint points on entities; converts associative dimensions to dynamic dimensions.
GcCoincident - applies a coincident geometrical constraint to two points or constrains a point to an entity.
GcCollinear - forces lines to be collinear.
GcConcentric - constrains the center points of circles, arcs, ellipses or elliptical arcs to coincide.
GcEqual - constrains arcs and circles to the same radius, or lines to the same length.
GcFix - constrains points and entities at a fixed position.
GcHorizontal - constrains lines or pairs of points to lie parallel to the X-axis of the current coordinate system.
GcParallel - forces two lines to be parallel to each other.
GcSmooth - forces a spline to maintain fluid geometric continuity with another spline, line, arc or polyline.
GcSymmetric - constrains two entities or points to lie symmetrically with respect to a selected line.
GcTangent - constrains two entities to maintain a point of tangency to each other or their extensions.
GcVertical - constrains lines or pairs of points to lie parallel to the Y-axis of the current coordinate system.
ConstraintBar - controls the display of the constraint bar of entities.
Delconstraint - removes all dimensional and geometrical constraints from an entity.