Generates parameters for a detail in order to easily change dimensions, angles, etc.

Make sure you run this command in the detail file and not in a project.

## Accessing the Command

Commandline: **BIMPARAMETRIZEDETAIL**

**: BimParametrizeDetail**

No prompts.

The parameters and constraints can be edited in the Mechanical Browser.

## Procedures

Parametrize and Edit a Wall-Slab Connection Detail

Parametrize and Edit a Structural Steel Connection

Propagate a Detail in a Project

Parametrizing a component automatically

Changing the parameters and constraints in the parameters manager

## Related Commands

BimCreateDetail - Creates a detail that can be saved in the library.

Parametrize - Adds constraints and parameters to pure geometric models.

ParametersPanelOpen - Opens the Parameters Panel.

ParametersPanelClose - Closes the Parameters Panel.

MechanicalBrowserOpen - Opens the Mechanical Browser panel.

SmParametrize - Creates a consistent set of 3D constraints for a selected sheet metal part. Recognizes rectangular array of holes on flanges.

DcAligned - Constrains the distance between two points.

DcAngular - Constrains the angle between two lines or linear polyline segments; the total angle of an arc or an arc polyline segment; or the angle between three points on entities.

DcConvert - Converts an associative dimension to a dimensional constraint.

DcDiameter - Constrains the diameter of a circle or an arc.

DcHorizontal - Constrains the horizontal distance (X-distance) between two points with respect to the current coordinate system.

DcLinear - Constrains the horizontal distance (X-distance) or vertical distance (Y-distance) between two points with respect to the current coordinate system.

DcRadius - Constrains the radius of a circle or an arc.

DcVertical - Constrains the vertical distance (Y-distance) between two points with respect to the current coordinate system.