SmLoft – BricsCAD Centro Assistenza

Crea parte di lamiera con piegature e flange da due curve non complanari.

Accessing the Command

command bar: smloft
menu bar: Sheet Metal | Create Sheet Metal Loft
toolbar: Sheet Metal | Create Sheet Metal Loft
ribbon: Sheet Metal | Create | Create Sheet Metal Loft

: SmLoft

Prompts you in the command bar:

Select two cross sections: (Select two, non coplanar open or closed 2D entities.)

Set [fillets Radius/Thickness/Single bend/Flanges with bends] <Flanges with bends>: (Press Enter or choose an option.)

Set [fillets Radius/Thickness/Single bend/Flanges with bends/thicken Inside/Both sides/thicken Outside] <thicken Inside>: (Press Enter or choose an option.)

Hit the CTRL key to adjust the alignment: Outside, Both Sides or Inside

Opzioni del comando

Opzione	Descrizione
Raggio dei raccordi	Sets radius of fillets which will be created on straight lines connection. Ti chiede: Select fillets radius <auto>: - (Do one of the following:) Digitare un valore per il raggio di raccordo. Press Enter to automatically calculate the minimal value for the fillet radius, which allows to create the model with the current thickness. Automatically calculated radius (left); user defined radius (right)
Altezza	Sets model thickness. Ti chiede: Select thickness <2.000000>: - (Type a value or press enter to accept the default value.)
Piegatura singola	Creates only lofted bend feature without any flanges. Curva a soppalco singola e vista aperta.
Flange con piegature	Crea una funzione di flangia per ogni segmento diritto delle entità 2D selezionate o una funzione di piegatura loft per segmenti curvi. Curva a soppalco singola e vista aperta.
	From left to right: thickening outside, both sides an inside.
Interno	Thickening direction is selected that way that 3D part is inside the selected 2D entities.
Entrambi i lati	Si ispessisce su entrambi i lati delle entità 2D selezionate.
EFinestra	Thickening direction is selected that way that 3D part is outside the selected 2D entities.