Constrains a line, linear polyline segment, or a pair of points to lie parallel to the Y-axis in the current coordinate system. (This command is equivalent to using the Vertical option of the GeomConstraint command.)
Note: This command moves one end of the segment so that the segment is vertical. The end that is moved is the end of the segment drawn second.
Accessing the Command
command bar: gcvertical
menu bar: Parametric | 2D Constraints | Vertical
ribbon: Parametric | 2D Constraints | Vertical
toolbar: 2D Constraints |
Prompts you in the command bar:
Select an entity or [2Points] <2Points>: (Select a line or linear polyline segment, or press Enter to select two points on one or two entities)
Select an entity
Select a line or a linear polyline segment; the program moves one end to make the entity vertical -- parallel to the Y-axis of the current coordinate system.
Constrains two pick points to the vertical; prompts you:
Pick two valid constraint points on the same entity or on two different entities. The two selected points are forced to lie on a line which is parallel to the Y-axis of the current coordinate system.
The program moves the second point horizontally so that it lies vertical to the first pick point; see figure below.
After you place the constraint, icons appear near the entities indicating the type of constraint. If you do not see them, then use the ConstraintBar command to display the icons.
Pause the cursor over one of the icons to see the location of the vertical constraint, shown by the two large X markers:
To remove a constraint, click the tiny x on the constraint bar.
GeomConstraint - applies geometric relationships between entities and/or points on entities.
Dimconstraint - applies a dimensional constraint to an entity or between constraint points on entities; converts associative dimensions to dynamic dimensions.
GcCoincident - applies a coincident geometrical constraint to two points or constrains a point to an entity.
GcCollinear - forces lines to be collinear.
GcConcentric - constrains the center points of circles, arcs, ellipses or elliptical arcs to coincide.
GcEqual - constrains arcs and circles to the same radius, or lines to the same length.
GcFix - constrains points and entities at a fixed position.
GcHorizontal - constrains lines or pairs of points to lie parallel to the X-axis of the current coordinate system.
GcParallel - forces two lines to be parallel to each other.
GcPerpendicular - constrains two lines to lie perpendicularly to each other.
GcSmooth - forces a spline to maintain fluid geometric continuity with another spline, line, arc or polyline.
GcSymmetric - constrains two entities or points to lie symmetrically with respect to a selected line.
GcTangent - constrains two entities to maintain a point of tangency to each other or their extensions.
ConstraintBar - controls the display of the constraint bar of entities.
Delconstraint - removes all dimensional and geometrical constraints from an entity.