Go to bricsys.com
Isolates layers associated with entities that you select in the drawing; all other layers are either locked or turned off (hidden); short for "layer isolate."
Note: Use the LayUnIso command to unlock or unhide isolated layers.
Accessing the Command
command bar: layiso
menu bar:Settings | Layers | Isolate Layer
ribbon: Home | Layers | isolate
toolbar: Layers | Isolate
: LayIso
Prompts you in the command bar:
Current setting: Lock layers
Select entities on the layer(s) to be isolated or [Settings]: (Pick one or more entities, or type S)
Entities in set: 1
Select entities on the layer(s) to be isolated or [Settings]: ((Pick more entities, or type S or press Enter to exit the command))
Number of isolated layers: xx.
Notes:
- When only one entity is selected (or multiple entities on the same layer) and this layer is not the current layer, BricsCAD reports:
This layer has been isolated: <LayerName>. This layer is current: <LayerName>. - When no entity on the current layer is selected, the layer of the most recently selected entity becomes the current layer. BricsCAD reports:
Number of isolated layers: xx. This layer is current: <LayerName>. - After running the LAYUNISO command, the layer that was current before is current again.
Opzioni del comando
|
Opzione |
Descrizione |
|
Select entities on the layer(s) to be isolated |
Selects one or more entities whose layers should be isolated; the prompt repeats itself until you press Enter so that you can isolate more than one layer. All other layers are locked or turned off. |
|
impostaZioni |
Specifies how layers and viewports should be isolated; prompts you: Enter setting for layers not isolated [Off/Lock] - (enter an option):
|
Comandi Correlati
Layer - creates layers and changes their properties in the Drawing Explorer.
-Layer - creates layers and changes their properties in the command bar.
LayerState - saves and restores layer states.
LayFrz - freezes layers associated with selected entities.
LayThw - thaws all frozen layers.
LayLck - locks layers associated with selected entities.
LayUlk - unlocks layers associated with selected entities.
LayOff - turns off layers associated with selected entities.
LayOn - turns on all layers that have been turned off.
LayUnIso - unisolates locked or turned off layers.
