SmRepair – BricsCAD Centro Assistenza

SmRepair restores the 3D solid model of a sheet metal part by thickening one of its sides: all thickness faces become perpendicular to flange faces.

Fixes problems specific to parts with lofted bend features: merges adjacent bends and provides tangential connections with flanges.

It also converts incorrect bends to regular bends. If a single, incorrect bend is selected, it will be repaired. If a 3D solid is selected, then all incorrect bends will be converted to regular bends.

Access the Command

: SmRepair

Prompts you in the command bar:

Select flange face or lofted bend face to repair or [switch on Local repairing/Scan for lost details]:

Switch on Local repairing: Select one wrong bend face, thickness faces, flange faces or side edges to repair or [switch on Global repairing]:

Scan for lost details: Enter scan tolerance <0.01>: (Press Enter or specify tolerance value.)

Verrà creato un corpo con facce di spessore perpendicolari alla faccia selezionata e senza curve adiacenti loft.

Notice that the size and position of the opening on the selected face is preserved and the size and position of the opening on the opposite face is adjusted.

Global repair

prima	dopo
Local repair (flange)

before (flange face is selected)	dopo
Local repair (incorrect bend)

before (incorrect bend face is selected)	dopo

Opzioni del comando

Opzione

Descrizione

Scansione per dati persi

Searches and retains model parts that remain after repair as separated bodies.

Ti chiede:

Enter scan tolerance <0.01>: - (Type a value or press enter to accept the default value.)

Scan tolerance: The fraction of the initial model volume, will be ignored and only larger bodies will be retained. E.g. if the scan tolerance = 0.25, only parts with a volume that is larger than 25% of the initial body will be retained.

From left to right:

Initial model with an unrecognized form feature.
Model after SmRepair without scanning for lost details: the circular feature is removed.
Model after SmRepair with scan. Two bodies are created: a horizontal flange with a hole and a separate body (highlighted in green color). Bodies can be unified with the Union command if required.

impostaZioni

Merge lofted bends:

If switched on, adjacent lofted bends with tangential connections will be merged to a single, lofted bend.

From left to right:

Initial model with two lofted bend features
Model after SmRepair without lofted bend repair: the hole is perpendicular to the features' faces.
Model after SmRepair with lofted bend repair: the two lofted bend features have been united to a single bend.

Procedures

Riparare un corpo in lamiera

Comandi Correlati

Riconosce automaticamente flange e piegature e piegature lofted in un solido 3D

SmDelete - restores a hard edge between two flanges to remove a bend or a junction: removes a flange with all the bends adjacent to it. The adjacent flanges are extended up to a junction configuration and the flange is deleted. Restores geometry removed by a miter.

SmDissolve - removes sheet metal data from the selected faces or entities.

Access the Command

Opzioni del comando

Procedures

Comandi Correlati

Articoli correlati

Non hai trovato quello che stai cercando?