Attaches point cloud files (that were previously converted to BricsCAD's BPT format) to the current drawing.
Accessing the Command
Toolbar: Point Cloud
Displays the Pre-process point cloud data file(s) dialog box.
|File name||Specifies the name of the point cloud file to attach. You can select from the following file types: E57, LAS, PTS, PTX, RCP, RCS, BPT.|
|Open||Opens the point cloud file, then displays the Attach Point Cloud dialog box; see below.|
|Cancel||Cancels the attachment process.|
After you click Open, the program displays a dialog box:
Specifies a name for the point cloud to be attached. You can use the name of the file, or give it another name.
Specifies the path to the folder holding the point cloud. The droplist lets you choose whether to
Specifies where the lower left corner of the point cloud should be located in the drawing
Specifies the size of the point cloud:
The point cloud is scaled relative to the insertion point.
Specifies the angle at which to position the cloud:
The point cloud is rotated relative to the insertion point.
Attaches the point cloud into the current drawing.
Cancels the attachment process.
PointCloud - opens the Drawing Explorer to the Point Cloud section; converts, loads, and unloads point cloud file attachments.
AttachmentsPanelOpen - displays the Attachments panel from which point clouds and other attachments can be loaded and controlled.
PointCloudBoundary - sets the display of the bounding box of point clouds.
PointCloudColorMap - colorizes the points based on Intensity, Elevation, and Classification of the point cloud.
PointCloudCrop - crops a point cloud entity, displaying only the part of the point cloud inside or outside a prismatic or cylindrical volume.
PointCloudPointMax - defines the maximum amount of points shown per point cloud.
PointCloudPointSize - specifies the size of points.
PointCloudPointSize_Minus - decreases the size of points.
PointCloudPointSize_Plus - increases the size of points.
PointCloudUncrop - removes all croppings from a point cloud.