Polecenie: SZKICUJ
A freehand sketch consists of a series of straight line segments, created either as individual line entities or as a polyline. Before you begin creating a freehand sketch, you must set the length, or increment, of each segment. The smaller the segments, the more accurate your sketch, but small segments increase the file size.
After you specify the length of the sketch segments, the crosshairs change to a pencil tool ().
A freehand sketch line is not added to the drawing until you "write" the sketch into your drawing.
Setting the Sketch Poly (SKPOLY) system variable
Whether a chain of individual lines or a polyline is created by the Sketch tool is controlled through the Sketch Poly (SKPOLY) system variable. When the setting is ON the Sketchtool creates polylines
Wykonaj jedno z poniższych:
- In the command bar type skpoly, then press Enter.
- In the Settings dialog, go to Drawing > Drafting > Entity Creation > Freehand Sketches.
.
Creating a freehand sketch
- Wykonaj jedno z poniższych
- Kliknij przycisk Szkicuj (
) z paska narzędzi Rysuj 2D.
- Wybierz polecenie Szkicuj z menu rozwijalnego Rysuj.
- Wpisz szkic w pasek poleceń, zatwierdź przyciskiem Enter.
You are prompted: Length of segments <current length>:
2. Aby określić długość segmentu wykonaj jedno z poniższych:
- Wciśnij Enter aby zaakceptować aktualną długość.
- Wpisz nową wartość w pasek poleceń, wciśnij Enter.
- Zdefiniuj długość graficznie, wybierając dwa punkty na rzutni.
The length of the segments is saved to the Sketch Increment (SKETCHINC) system variable.
3. Click to start sketching (pen down). The crosshairs are replaced by the Pencil tool ()
You are prompted: Press ENTER or click to toggle Pen/Quit without save/Record (save)/Erase/Connect/Straight/eXit with save::
A prompt menu displays:
4. Aby szkicować rusz kursorem.
Linia szkicu wyświetli się w kolorze zielonym.
5. (opcjonalnie) Kliknij lewy klawisz myszy aby zatrzymać szkicowanie (pisak w górę), kliknij ponownie (pisak w dół) aby wznowić szkicowanie.
6. (opcjonalnie) Wybierz Wymaż w menu podpowiedzi lub wpisz W + Enter aby zacząć wymazywać linie szkicu.
Kursor zmienia się w narzędzie Wymaż ().
- Rusz kursor w kierunku końca linii szkicu, aby zacząć wymazywanie.
- Kliknij aby zatrzymać usuwanie i przywrócić szkicowanie
7. (opcjonalnie) Wybierz Zapisz w menu podpowiedzi lub wpisz Z + Enter aby zapisać linie szkicu, i nadal szkicować.
8. (opcjonalnie) Wybierz zapisz i wYjdź z menu kontekstowego lub wpisz Y + Enter aby zapisać stworzone linie i zakończyć polecenie.
9. (opcjonalnie) Wybierz Wyjdź bez zapisywania w menu kontekstowym lub wpisz Q + Enter aby wyjść z komendy szkic bez zapisywania zmian.