POINTCLOUDREGION command

Creates regions in a point cloud.

Method

To create regions, first select one method:

Draw a selection of points.
If the current drawing has more than one point cloud attached, you are first prompted to select one.
If the current drawing has only one point cloud attached, it is automatically selected for the crop operation.
You can then immediately start selecting points based on the previously selected drawing option (shown as <default>).
Alternatively, select a different drawing option and proceed with the points selection. Select more points or finish the selection process.
Select solids or crop solids.
If there are more point clouds attached in the drawing, you are first prompted to select one. Then you can select solids or polysolids to convert to regions.

The created regions are displayed in the Point Cloud Manager panel.

Draw

Allows you to select parts of the point cloud to convert to a region.

Convert

Converts solids or crop solids to regions.

Select solids or polysolids to convert: Allows you to select solids or polysolids to convert to a region.

Note: The solids or crop solids are not deleted after the region is created.

Some of the selected solids are not cropsolids, do you want to convert them?

Allows you to choose between Yes and No.

Select point cloud entity: If there are more point clouds attached in the drawing, it allows you to select the point cloud for which you can create regions.

Note: Press the Esc key to exit the command.